Replacing the display panel
NOTE: Before working inside your computer, read the safety information that shipped with your computer and follow
the steps in Before working inside your computer. After working inside your computer, follow the instructions in After
working inside your computer. For more safety best practices, see the Regulatory Compliance home page at www.dell.com/
regulatory_compliance.
Topics:
• Procedure
• Post-requisites
Procedure
1. Place the display panel on a flat surface.
2. Replace the display cable.
3. Replace the sensor board.
4. Replace the camera.
5. Turn the display-panel assembly over.
6. Route the display cable through the routing guide inside the hinge cover.
7. Align the tabs on the display-panel assembly with the slots on the display back-cover and antenna assembly and gently snap
the display-panel assembly into place.
Post-requisites
1. Replace the display assembly.
2. Replace the wireless card.
3. Replace the battery.
4. Replace the base cover.
44
Replacing the display panel 75
To Next Page
Loading...
