Turning Your Projector On
NOTE: Turn on the projector before you turn on the source (computer, DVD player, etc.). The Power button light glows white
until pressed.
1 Connect the power cord and appropriate signal cables to the projector.
2 Press the Power button on the remote control.
3 Turn on your source (computer, DVD player, etc).
4 Connect your source to the projector using the appropriate cable.
5 By default, the input source of the projector is set to VGA-In. Change the input source of the projector if necessary.
6 If you have multiple sources connected to the projector, press the Source button on the remote control to select the desired source.
6
10 Turning Your Projector On
To Next Page
