• 1920 x 1080p @ 23.98/24 Hz Frame Packing
• 1920 x 1080i @ 50 Hz Side by Side Half
• 1280 x 720p @ 50 Hz Top and Bottom
• 1280 x 720p @ 59.94/60 Hz Top and Bottom
• 1920 x 1080p @ 23.98/24 Hz Top and Bottom
3D FORMAT: Allows you to select the 3D format when the 3D display function is activated. Options are: Side By Side, Side By Side Full,
Frame Sequential, Field Sequential, Top/Bottom, and Frame Packing.
3D SYNC INVERT: If you see a discrete or overlapping image while wearing DLP 3D goggles, you may need to execute 'Invert' to get best
match of left/right image sequence to get the correct image. (For DLP 3D goggles)
PROJECTOR SETTINGS
Select and press to activate projector settings.
The projector settings menu provides the following options:
Auto Source: Select Off (the default) to lock the current input signal. If you press the Source button when the Auto Source mode is set
to Off, you can manually select the input signal. Select On to auto detect the available input signals. If you press the Source button when
the projector is on, it automatically finds the next available input signal.
PROJECTOR MODE: Allows you to select the projector mode, depending upon how the projector is mounted.
Rear Projection-Desktop: The projector reverses the image so that you can project from behind a translucent screen.
Rear Projection-Ceiling Mount: The projector reverses and turns the image upside down. You can project from behind a translucent
screen with a ceiling-mounted projection.
Front Projection-Desktop: This is the default option.
Front Projection-Ceiling Mount: The projector turns the image upside down for ceiling-mounted projection.
SPEAKER: Select On to enable the speaker. Select Off to disable the speaker.
TEST PATTERN: Test Pattern is used to test focus and resolution. You can enable or disable the Test Pattern by selecting Off, Test
Pattern 1, or Test Pattern 2.
26
Advanced Settings
To Next Page
Loading...
