Horizontal Position: Press to move the image right and to move the image left.
Vertical Position: Press to move the image up and to move the image down.
Frequency: Allows you to change the display data clock frequency to match the frequency of your computer’s graphics card. If you see a
vertical flickering wave, use the Frequency control to minimize the bars. This is a coarse adjustment.
Tracking: Synchronize the phase of the display signal with the graphic card. If you experience an unstable or flickering image, use Tracking
to correct it. This is a fine adjustment.
Aspect Ratio: Allows you to select the aspect ratio to adjust how the image appears. Options are: Origin, 16:10, 16:9, and 4:3.
• Origin — Select Origin to maintain the aspect ratio of the image projector according to the input source.
• 16:10 — The input source scales to fit the width of the screen to project a 16:10 screen image.
• 16:9 — The input source scales to fit the width of the screen to project a 16:9 screen image.
• 4:3 — The input source scales to fit the screen and projects a 4:3 image.
Zoom: Press and to zoom and view the image.
Adjust the image scale by pressing or and press to view on your remote control only.
Press to activate the Zoom Navigation menu. Use to navigate the projection screen.
3D Display: Select On to activate the 3D display function (default is Off).
Advanced Settings
23
To Next Page
