Draining residual flea power, also known as a performing a "hard reset", is also a common troubleshooting step if your computer
does not power on or boot into the operating system.
To drain residual flea power (perform a hard reset)
Steps
1. Turn off your computer.
2. Disconnect the power adapter from your computer.
3. Remove the base cover.
4. Remove the battery.
5. Press and hold the power button for 20 seconds to drain the flea power.
6. Install the battery.
7. Install the base cover.
8. Connect the power adapter to your computer.
9. Turn on your computer.
NOTE: For more information about performing a hard reset, search in the Knowledge Base Resource at www.dell.com/
support.
LED Indicators and Characteristics
Battery charge and status LED
Table 14. Battery charge and status LED Indicator
Power Source LED Behavior computer Power State Battery Charge Level
AC Adapter Off S0 - S5 Fully Charged
AC Adapter Solid White S0 - S5 < Fully Charged
Battery Off S0 - S5 11-100%
Battery Solid Amber (590+/-3 nm) S0 - S5 < 10%
● S0 (ON) - Computer is turned on.
● S4 (Hibernate) - The computer consumes the least power compared to all other sleep states. The computer is almost at an
OFF state, expect for a trickle power. The context data is written to hard drive.
● S5 (OFF) - The computer is in a shutdown state.
114
Troubleshooting
To Next Page
Loading...
Need help?
General
