Steps
1. Locate the DC-in slot on your computer.
2. Insert the DC-in port into the slot on your computer.
3. Connect the DC-in cable to the system board.
4. Place the DC-in metal bracket on the DC-in port.
5. Install the two screws (M2x5) that secure the DC-in metal bracket to the system board.
Next steps
1. Install theheat sink (for discrete only).
2. Install the battery.
3. Install the base cover.
4. Follow the procedure in After working inside your computer.
Solid-state drive
Removing the SSD
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
40
Disassembly and reassembly
To Next Page
Loading...
