Console(config-if)#
Console(config-if)#description RD SW#3
Console(config-if)#no negotiation
Console(config-if)#speed-duplex 100half
Console(config-if)#flowcontrol
Trunk Configuration
On the Trunk Configuration page, you can enable and disable the aggregate port links that have been created on the switch. To set up trunks and select port
members, use the Link Aggregation page.
For each trunk number listed in the Trunk column, you can change the following parameters listed by column name on the screen:
l Name/Type — Allows a user-defined label for the trunk and also indicates the type of ports in the trunk
l Admin/Oper — Allows the network administrator to manually disable a trunk and also indicates the status of the link: up or down
l Speed/Duplex Mode — Allows the manual selection of port speed and duplex mode and also indicates the current speed and mode of member ports
l Flow Control — Allows automatic or manual selection of support for flow control and also indicates the type of flow control currently in use
l Autonegotiation/Port Capabilities — Allows autonegotiation to be enabled/disabled for all ports in the trunk and also indicates the capabilities of the
port members
To save any changes you make in this page, click Apply Changes. If you don't want to save the changes, click Refresh.
CLI Commands
The following table summarizes the equivalent CLI commands for items in the Ports/Trunks Configuration page.
Example
Console(config)#interface port-channel 1
Console(config-if)#
Console(config-if)#description RD SW#3
To Next Page
Loading...
