Dell PowerConnect 5224 - Queue Scheduling

CLI Commands
The following table summarizes the equivalent CLI commands for items in the Class of Service/Traffic Classes page.
Example
Console(config)#queue cos-map 0 0 1 2
Console(config)#queue cos-map 1 3
Console(config)#queue cos-map 2 4 5
Console(config)#queue cos-map 3 6 7
Console#show queue cos-map
Information of Eth 1/1
QueueIDTrafficclass
---------------------
0012
13
245
367
.
.
.
Queue Scheduling
In the Queue Scheduling page, you can configure Weighted Round Robin (WRR) queueing for the switch ports.
The following options are available:
l WRR Setting Table — Displays a list of weight values for each switch CoS queue
l Weight Value — Sets a new weight value for a CoS
To change a table setting, select the entry in the WRR Setting Table, type the new weight in the Weight Value box, and then click Apply Changes. If you
don't want to save the changes, click Refresh.
Command
Usage
queue cos-map queue_id [cos1 ... cosn]
Assigns traffic class values to the CoS priority queues.
Use the no form command to set the CoS map to the default values.
show queue cos-map [interface]
Shows the CoS priority map.