CLI Commands
The following table summarizes the equivalent CLI commands for items in the Switch/IP Address page.
Example
Console(config)#interface vlan 1
Console(config-if)#ip address 192.168.1.5 255.255.255.0
Console(config-if)#exit
Console(config)#ip default-gateway 192.168.1.254
Console(config)#
DHCP
In the DHCP page, click Restart DHCP to release the current IP address and obtain a new one through DHCP.
CLI Commands
The following table summarizes the equivalent CLI command for items in the Switch/IP Address/DHCP page.
Security
The Security page contains links to the following information:
ip address {ip-address
netmask | bootp | dhcp}
Sets the primary IP address for this device. Use the no form command to
remove the IP address, or to disable IP address assignment through BOOTP or
DHCP.
ip default-gateway
gateway
Establishes a static route between the switch and management stations that
exist on another network segment.
Displays the usability status of an IP interface.
Shows the default gateway configured for this device.
NOTICE: If Restart DHCP is selected when IP settings have been configured statically, a warning message indicating that the IP Address Mode is not
set to DHCP displays.
Resubmits a DCHP client request
To Next Page
Loading...
