Dell PowerConnect 5224 - IGMP Member Port Table; Multicast Router Port Settings

Querytime-out: 300 sec
IGMPsnoopingversion:Version1
Console#
IGMP Member Port Table
You can use the IGMP Member Port Table page to assign ports that are attached to hosts that are supposed to receive a specific multicast service.
The following options are available:
l VLAN ID — Specifies the VLAN ID
l Multicast IP Address — Allows you to select or add the IP address for a specific multicast service
l New IP Address — Specifies the IP address of a new multicast service
l Port/Trunk Toggle Buttons — Allows you to select ports or trunks to receive the specified multicast service by toggling the value of the port/trunk
button:
¡ 'S' — Statically sets a port or trunk as a group member of the multicast service
¡ 'D' — Indicates that a port or trunk has been dynamically set as a group member of the multicast service
¡ 'BLANK' — Indicates that the port or trunk is not a group member of the multicast service
To save any changes you make in this page, click Apply Changes. If you don't want to save the changes, click Refresh.
CLI Commands
The following tables summarize the equivalent CLI commands for items in the Multicast Support/IGMP Member Port Table page.
Example
Console(config)#ip igmp snooping vlan 1 static 224.1.2.3 ethernet 1/11
Console(config)#exit
Console#show bridge 1 multicast
VLAN M'cast IP addr. Member ports Type
---- --------------- ------------ -------
1224.1.2.3Eth1/11User
Console#
Multicast Router Port Settings
You can use the Multicast Router Port Settings page to display or set ports on the switch that are attached to a neighboring multicast router/switch for each
NOTICE: You must set at least one port or trunk as a static member before you add a new multicast IP address. If you remove all static members from
a group, the IP address is also removed.
Command
Usage
ip igmp snooping vlan vlan-id static ip-address interface
Adds a port to a multicast group
show bridge bridge-group multicast [vlan vlan-id] [user | igmp-
snooping]
Shows the multicast list with MAC and IP
addresses