VLAN ID.
The following options are available:
l VLAN ID — Specifies the VLAN ID
l Port/Trunk Toggle Buttons — Allows you to select ports or trunks that are attached to a neighboring multicast router/switch by toggling the value of
the port/trunk button:
¡ 'S' — Statically attaches a port or trunk to a multicast router/switch
¡ 'D' — Indicates that a port or trunk has been dynamically attached to a multicast router/switch
¡ 'BLANK' — Indicates that the port or trunk is not attached to a multicast router/switch
To save any changes you make in this page, click Apply Changes. If you don't want to save the changes, click Refresh.
CLI Commands
The following table summarizes the equivalent CLI commands for items in the Multicast Support/Multicast Router Port Settings page.
Example
Console(config)#ip igmp snooping vlan 1 mrouter ethernet 1/5
Console(config)#exit
Console#show ip igmp snooping mrouter vlan 1
VLAN M'cast Router Port Type
---- ------------------ -------
1Eth1/5Static
Console#
Statistics
From the Statistics page, you can chart a variety of system data. You can see the value of each bar or line in the chart by clicking the bar. For each chart, after
you have set all the variables, click Draw.
The Statistics page contains links to the following pages:
l Chart
l Table
Chart
To Next Page
Loading...
