Dell PowerConnect 5224 - Page 47

The Chart page compares one type of statistic across all ports or trunks. You must define the following variables:
l Statistics — Specifies the type of system data to monitor
l Refresh Rate — Specifies the time interval between automatic refreshes
Table
The Table page lists, in table format, all statistics counters for a specific port or trunk. You must specify the port or trunk from the drop-down menus, and then
click Query.
CLI Commands
The following table summarizes the equivalent CLI commands for items in the Statistics/Table page.
Example
Console#show interfaces counters ethernet 1/17
Ethernet 1/17
Iftablestats:
Octetsinput:91248,Octetsoutput:343887
Unitcastinput:680,Unitcastoutput:593
Discardinput:0,Discardoutput:0
Errorinput:0,Erroroutput:0
Unknownprotosinput:0,QLenoutput:0
Extendediftablestats:
Command
Usage
show interfaces counters interface
Statically configures a multicast router port
clear counters interface
Clears statistics on an interface
NOTE: ClearingcountersareonlyavailableintheCLI.