l If the target switch has also enabled LACP on the connected ports, the trunk will automatically activate.
l If more than four ports attached to the same target switch have LACP enabled, the additional ports enter standby mode and will only be enabled if one
of the active links fails.
l STP, VLAN, and IGMP settings can only be made for the entire trunk through the specified port-channel.
To add a port to a static trunk, click the Static toggle button below the port number until the correct trunk number appears. To make a port available for an
LACP trunk, click the LACP toggle button below the port number until an L appears.
To save any changes you make in this page, click Apply Changes. If you don't want to save the changes, click Refresh.
CLI Commands
The following table summarizes the equivalent CLI commands for items in the Link Aggregation/Trunk Settings page.
Example
Console(config)#interface port-channel 1
Console(config-if)#exit
Console(config)#interface ethernet 1/11
Console(config-if)#channel-group 1
Console(config-if)#exit
Console(config)#interface ethernet 1/8
Console(config-if)#lacp
Console(config-if)#
SNMP
The SNMP page contains links to the following pages:
l Communities
l Traps
Communities
On the Communities page, you can create different communities and customize access. The public string has read-only privileges by default.
NOTICE: In order for a port to join an existing trunk through LACP, the port's Flow Control, Speed and Duplex Mode, and Autonegotiation settings must
match those of the existing trunk.
To Next Page
Loading...
