data from becoming corrupted.
Release 3.1.4.5
Description User Impact Resolution
IGMP Querier does not work if IP
Multicast not enabled.
User must enable IP multicast in order
for IGMP Querier to function properly.
Automatically enable IP Multicast
when IGMP is enabled.
Sending multiple DHCP discoveries to
the switch results in log messages on
the console.
Sending multiple DHCP discoveries to
the switch results in log messages on
the console.
The driver modified to handle MAC
addresses correctly to prevent the
log messages.
Radius Servers always show active
status.
The RADIUS Server Status web page
was always displaying the server’s
status as active.
Retrieved the server status the
same as the CLI for each row in the
web page display.
PFC frames received per priority
queue are always shown as zero.
Per priority PFC frames received
count is always zero.
PFC frames statistics are not
properly reported.
productIdentificationPerUnitTable OID
was re-numbered when banner OIDs
were inserted.
Management applications that use the
OID in the 3.1.1.9 release will not
work properly.
Reverted the OID to the proper
value used on the other
PowerConnect switches.
BPDU protection fails when port is in
dot1x un-authorized state.
When the port is in Dot1x
Unauthorized mode STP bpdus will
not be allowed to the Dot1s
application and increase CPU
utilization.
Allow STP BPDUs without
considering the dot1x authorized
state of the port.
Code Download is getting failed with
HTTPs as management session and
downloading protocol as HTTP.
Code Download is getting failed with
HTTPs as management session and
downloading protocol as HTTP.
Pass correct file path when HTTP is
selected as the download method.
Service Port MAC address is not valid The OOB port is not using the correct
MAC address, even though the output
of "show ip interface out-of-band"
shows the correct MAC address.
Initialized driver to properly process
the MAC Address.
To Next Page
Loading...
