Dell PowerEdge KVM 1081AD - Locking and Unlocking User Accounts

108 Managing Your Remote Console Switch Using the On-board Web Interface
5 Click Save to save the settings and return to the main on-board web
interface
window.
To change the user password:
1
Click the Configure tab in the on-board web interface, then click the
Users category in the left column.
2 Click a user name in the Users column to modify an existing user. The
Add/Modify User window appears.
3 Type the password for that user in the Password box and then repeat the
password in the
Verify Password box. The password must be 5-16
characters and contain alphabetical characters of mixed case and at least
one number.
4 Click Save to return to the on-board web interface.
To delete a user:
1
Click the Configure tab in the on-board web interface, then click the
Users category in the left column.
2 Select the check box next to the user name you wish to delete.
3 Click the Delete button on the left side of the window. A confirmation
window appears.
4 Click Yes to confirm the deletion.
-or-
Click
No to exit the window without deleting the user.
Locking and Unlocking User Accounts
If a user enters an invalid password five consecutive times, the Security Lock-
Out feature, if enabled, will temporarily disable that account. If a user
attempts to log in again, an appropriate error message is displayed.
NOTE: All accounts (User, User Administrator, and Remote Console Switch
Administrator) are subject to this lock-out policy.
A Remote Console Switch Administrator can specify the number of hours (1
to 99) that accounts will remain locked. When Enable Lock-outs is
unchecked, the security lock-out feature will be disabled and no users will be
locked out.