Controlling Your System at the Analog Ports 61
1
to launch the OSCAR interface. The
Main
dialog
box appears.
2
Click
Setup - PDUs
.
3
Complete one of the following steps:
Select a PDU name, then click
Settings
to open the
PDU Settings
window.
-or-
Select a PDU name, then press <Enter> to open the
PDU Settings
window.
-or-
Double-click on the PDU name to open the
PDU Settings
window.
4
Complete any of the following steps:
a
In the
Name
field, enter the PDU name.
b
In the
Cycle Delay
field, enter the number of seconds you want the
Remote Console Switch to wait between turning off and turning on.
5
Click
OK
.
PDU Inlets window
From the Inlets window, you can view and modify inlet parameters.
NOTE: You can only modify inlet parameters on a PDU that is currently online.
To view/modify PDU Inlet settings:
1
to launch the OSCAR interface. The
Main
dialog
box appears.
2
Click
Setup - PDUs
.
3
Complete one of the following steps:
Select a PDU name, then click
Settings
to open the
PDU Settings
window.
-or-
Select a PDU name, then press <Enter> to open the
PDU Settings
window.
-or-
Double-click on the PDU name to open the
PDU Settings
window.
To Next Page
Loading...
