Installation 31
1 Mount the PEM into your rack. Using up to nine CAT 5 cables, one
connects your Remote Console Switch unit to the PEM, and the other
eight connect the PEM to the SIP attached to each device.
2 Attach one end of the CAT 5 cabling that will run between your PEM
and the Remote Console Switch unit to the RJ-45 connector slightly
separated from the other connectors on the PEM. Connect the
remaining end of the CAT 5 cable to the desired ARI port on the back of
your Remote Console Switch unit.
3 To one of the eight RJ-45 connectors grouped on the back of the PEM,
attach the CAT 5 cabling that will run between your PEM and each
device’s SIP.
4 Connect the other end of the CAT 5 cable to the first of the SIPs.
5 Repeat steps 3-4 for all devices you wish to attach.
Figure 2-14. Remote Console Switch Configuration With a PEM
To Next Page
Loading...
