Figure 106. Install the system board
1.
touch point (2) 2. screw (8)
3. system board
Next steps
1. If required, install the Trusted Platform Module (TPM). See, the Installing the Trusted Platform Module section.
2. Reinstall the following components:
a. expansion card riser
b. memory modules
c. heat sink and processor
d. cooling shroud
e. iDRAC port card, if removed
f. internal dual SD module, if removed
3. Reconnect all cables to the system board.
NOTE: Ensure that the cables inside the system are routed through the cable routing latch.
4. Follow the procedure listed in the After working inside your system section.
145
To Next Page
Loading...
