Dell PowerEdge R330 - System memory

1. Ensure that you follow the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
Steps
1. Align the guide on the cooling shroud with the guide pin on the chassis wall.
2. Lower the cooling shroud into the chassis until it is rmly seated.
When rmly seated, the memory socket numbers marked on the cooling shroud align with the respective memory sockets.
Figure 22. Installing the cooling shroud
1.
cooling shroud 2. guide on the cooling shroud
3. guide pin on the chassis wall
Next steps
Follow the procedure listed in After working inside your system.
System memory
Your system supports DDR4 ECC unbuered DIMMs (UDIMMs).
NOTE: MT/s indicates memory module speed in Mega Transfers per second.
Memory bus operating frequency can be 1600 MT/s, 1866 MT/s, 2133 MT/s, or 2400 MT/s depending on the following factors:
• System prole selected (for example, Performance Optimized, Custom, or Dense Conguration Optimized)
• Maximum supported memory module frequency of the processors
The system contains four memory sockets — two sets of 2–sockets each. Each 2–socket set is organized into one channel. In each
2-socket set, the rst socket release lever is marked white and the second socket release lever is marked black.
60