Dell POWEREDGE R805 - Removing the Riser 2 Board from the Expansion-Card Bracket

102 Installing System Components
Figure 3-18. Removing and Replacing Expansion-Card Riser 2
Removing the Riser 2 Board From the Expansion-Card Bracket
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet.
2 Open the system. See "Opening the System" on page 71.
3 Remove any expansion cards from the expansion-card riser 2. See
"Removing an Expansion Card" on page 92.
4 Remove expansion-card riser 2. See "Removing Expansion-Card Riser 2"
on page 101.
1 expansion-card riser 2 2 release latches (2)
3 pin collars (2) 4 mounting pins (2)
1
3
2
4