Dell POWEREDGE R805 - Removing the Optical Drive from the Optical Drive Tray

112 Installing System Components
Figure 3-23. Cabling the Optical Drive
Removing the Optical Drive From the Optical Drive Tray
Pull outward on the tab at the back of the carrier on the left side and
simultaneously pull up on the left side of the optical drive to separate the
drive from the tray. See Figure 3-24.
1 SATA connector (SATA_A) on system
board
2 SATA interface cable
3 routing tabs in chassis side wall 4 optical-drive SATA connector
5 optical drive power cable 6 CD_PWR connector on backplane
4
1
3
2
5
6