110 Installing System Components
4
To remove the optical drive, pull up on the blue release tab at the back of
the optical drive tray and push the tray out of the system. See Figure 3-24.
Installing the Optical Drive
1
Align the optical drive tray with its opening in the front panel. See
Figure 3-22.
2
Slide in the drive tray until the tray snaps into place.
3
Connect the optical drive cable to the back of the drive tray.
4
If not already done, connect the power and interface cables from the
optical drive to the SAS/SATA backplane and system board connectors.
a
Connect the power cable to the CD_PWR connector on the
backplane board. See Figure 6-3 for the location of the connector and
Figure 3-22 for the routing of the cable.
b
Route the interface cable along the inside right chassis side panel,
inserting the cable under each of the cable routing tabs. See
Figure 3-23.
c
Connect the cable to the SATA_A connector on the system board. See
Figure 6-2 for the location of the connector.
5
Close the system. See "Closing the System" on page 71.
6
Replace the bezel. See "Replacing the Front Bezel" on page 70.
7
Reconnect your system and peripherals to their electrical outlets, and turn
on the system.
To Next Page
Loading...
