Installing System Components 85
Figure 3-10. Installing a SAS Controller Daughter Card
5
Attach one end of the interface cable to connector 0 on the SAS controller
and the other end to the backplane SAS connector. See Figure 3-11.
NOTE: Be sure to connect the cable according to the connector labels on the
cable. The cable is not operational if reversed.
1 SAS controller daughter card 2 sideplane
3 SAS controller daughter card socket 4 release tab
5 RAID battery connector (battery-
cached SAS RAID controller only)
6 cutout
7 SAS cable (1) 8 SAS connector(s) (1 or 2) (only SAS 0
used)
2
5
7
4
3
8
1
6
To Next Page
Loading...
