Dell PowerEdge R815 - Security; Cover Latch; Bezel; Hard Drive

Dell
PowerEdge R815 Technical Guide 19
• Two external USB 2.0 connectors (with an internal USB connector and Optional Internal SD
Module)
• 15-pin VGA connector
For detailed information on the control panel, see Front-Panel Features and Indicators section in the
About Your System chapter in the PowerEdge R815 Hardware Owner’s Manual.
The LCD panel is a graphics display controlled by iDRAC6. Error codes can be sent to the display by
either iDRAC6 or BIOS.
BIOS has the ability to enter a Secure Mode through Setup, which will lock the Power and NMI
buttons. When in this mode, pressing either button has no effect but does not mask other sources of
NMI and power control.
Figure 8. LCD Panel
For information on LCD Panel Features, see LCD Panel Features section in the About Your System
chapter of the PowerEdge R815 Hardware Owner’s Manual.
3.13 Security
3.13.1 Cover Latch
A tooled entry latch is provided on the top of the unit to secure the top cover to the chassis. See the
Opening and Closing the System section in the Installing System Components chapter of the
PowerEdge R815 Hardware Owner’s Manual.
3.13.2 Bezel
A metal bezel is mounted to the chassis front to provide the Dell ID. A lock on the bezel is used to
protect un-authorized access to system peripherals and the control panel. System status via the LCD
is viewable even when the bezel is installed.
The bezel is optional for PowerEdge R815 systems. For more information, see the Front Bezel
(Optional) section in Installing System Components chapter of the PowerEdge R815 Hardware
Owner’s Manual.
3.13.3 Hard Drive
The optional front bezel of the system contains a lock. A locked bezel secures the system hard
drives. See Hard Drives
in the Hardware Owner’s Manual.