Dell PowerEdge R940 - Installing 14 G Systems in Sliding Rails

NOTE: The 2U system requires two people for installation due to its heavier weight.
Installing 14G Systems in Sliding Rails
To install the 14G system in sliding rails:
1 Pull the inner slide rails out of the rack until they lock into place.
• Hold the system by its front and back ends and tilt the front end upward slightly.
• Check the window on the sides of both rails to conrm that the heads of the standos are visible before adjusting or releasing
your grip on the back end of the system.
• Use your free hand to hold the rail against the side of the chassis if needed as the system is rotated downward into the remaining
J-slots.
2 Locate the rear rail stando on each side of the system and lower them into the rear J-slots of the slide assembly.
3 Rotate the system downward until all the rail standos are seated in the J-slots.
4 Push the system inward until the lock levers click into place. Press the slide-release lock buttons on both rails and slide the system into
the rack.
30
Rack Rails