74 Installing System Components
See the documentation for the card for information about the card’s cable
connections.
9
Close the system. See "Closing the System" on page 47.
10
Reconnect the system to the electrical outlet, and turn on the system and
attached peripherals.
11
Install any device drivers required for the card as described in the
documentation for the card.
SAS Controller Expansion Card
Read the installation instructions in the documentation for your SAS
controller card. Install the card in expansion card connector SLOT1 or
SLOT2 (see "Installing an Expansion Card" on page 73), and connect the
hard-drive activity indicator cable from the card to the AUXLED connector
on the system board (see Figure 6-2 for the connector location). Fasten the
cables to the slots as indicated in Figure 3-19 to manage the slack.
book.book Page 74 Wednesday, June 24, 2009 8:21 AM
To Next Page
Loading...
