Dell PowerEdge T100 Series - Installing the Chassis Intrusion Switch

Installing System Components 95
3 Disconnect the chassis intrusion switch cable from the INTRUSION
SWITCH connector on the system board. See Figure 3-28.
4 Slide the chassis intrusion switch out of the securing bracket notch. See
Figure 3-28.
5 Remove the switch and its attached cable from the system.
Figure 3-28. Removing and Installing the Chassis Intrusion Switch
Installing the Chassis Intrusion Switch
1 Align the chassis intrusion switch with the securing bracket notch. See
Figure 3-28.
2 Slide the switch into the securing bracket notch.
1 chassis intrusion switch 2 securing bracket notch
3 INTRUSION SWITCH connector
1
2
3
book.book Page 95 Wednesday, June 24, 2009 8:21 AM