Dell PowerEdge T110 II - Installing an EMI Filler Panel

64 Installing System Components
3 Remove the front bezel. See "Removing the Front Bezel" on page 61.
4 Slide the drive release latch in the direction of the arrow to release the
shoulder screw. See Figure 3-5.
5 Pull the tab to remove the EMI filler panel.
Figure 3-5. Removing and Installing the EMI Filler Panel
Installing an EMI Filler Panel
1 Gently slide the EMI filler panel into the bay until it clicks into place. See
Figure 3-5.
2 Replace the front bezel. See "Installing the Front Bezel" on page 62.
3 Close the system. See "Closing the System" on page 60.
1 drive release latch 2 shoulder screws (2)
3 EMI filler panel 4 tab
3
2
4
1
Coaster_HOM.book Page 64 Monday, November 3, 2014 3:23 PM