Dell PowerEdge T110 II - Page 71

Installing System Components 71
Figure 3-9. Removing or Installing a 3.5-Inch Hard Drive
NOTE: If you are not replacing the hard drive, remove the drive from the drive
bracket (see Figure 3-11) and insert the empty bracket back into the drive bay.
5 Detach the hard-drive bracket from the hard drive by pushing out at the
edges of the bracket and removing the hard drive. See
Figure 3-11 .
6 Close the system. See "Closing the System" on page 60.
7 Place the system upright on a flat, stable surface.
8 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
1 hard drive 2 power/data cable
3 tabs (2) 4 hard drive bracket
2
4
3
1
Coaster_HOM.book Page 71 Monday, November 3, 2014 3:23 PM