Installing System Components 77
2
Open the system. See "Opening the System" on page 59.
3
To remove the existing hard-drive bracket, see step 4 of "Removing a 2.5-
Inch Hard Drive" on page 74.
4 Slide the hard-drive carrier back in the hard drive bay
.
5
Slide the hard drive into the drive bay until it snaps into place.
6
Secure the hard drive to the hard-drive bracket using the four screws. See
Figure 3-13.
7
Connect the power/data cable to the hard drive. See Figure 3-14
Figure 3-14. Attaching Power/Data Cable to the Hard Drive
8
Close the system. See "Closing the System" on page 60.
9
Place the system upright on a flat, stable surface.
1 power/data cables 2 hard drives
Coaster_HOM.book Page 77 Monday, November 3, 2014 3:23 PM
To Next Page
Loading...
