System health and system ID indicator codes
The system health and system ID indicator is located on the left control panel of the system.
Figure 7. System health and system ID indicator
Table 27. System health and system ID indicator codes
System health and system ID
indicator code
Condition
Solid blue Indicates that the system is powered on, is healthy, and system ID mode is not active.
Press the system health and system ID button to switch to system ID mode.
Blinking blue Indicates that the system ID mode is active. Press the system health and system ID
button to switch to system health mode.
Solid amber Indicates that the system is in fail-safe mode. If the problem persists, see the Getting
help section.
Blinking amber Indicates that the system is experiencing a fault. Check the System Event Log
for specific error messages. For information about the event and error messages
generated by the system firmware and agents that monitor system components, go
to qrl.dell.com > Look Up > Error Code, type the error code, and then click Look it
up.
GPU fan LED indicator codes
The GPU fan LED indicators are on the GPU fans in front of the system.
Table 28. GPU fan LED indicators codes
State GPU fan LED
indicator code
Condition
S0 Solid Green Indicates that the fan is healthy.
20 System diagnostics and indicator codes
To Next Page
Loading...
