Table 2. Rear view of the system (continued)
Item Ports, panels, or slots Icon Description
NOTE:
● To reset iDRAC using system ID, ensure that the system ID
button is enabled in the iDRAC setup.
● If the system stops responding during POST, press and hold
the system ID button (for more than 5 seconds) to enter
the BIOS progress mode.
6
iDRAC dedicated port Enables you to remotely access iDRAC. For more information, see
the iDRAC User's Guide at www.dell.com/poweredgemanuals.
7 USB 2.0 port (1) This port is USB 2.0-compliant.
8 USB 3.0 port (1) This port is USB 3.0-compliant.
9 VGA port Enables you to connect a display device to the system. For more
information, see the www.dell.com/poweredgemanuals.
10 PCIe expansion card riser
4 (slot 7 and slot 8)
N/A The expansion card riser enables you to connect PCI Express
expansion cards. For more information on the expansion
cards that are supported on your system, see www.dell.com/
poweredgemanuals.
11 Power supply unit (PSU
4)
For more information on the PSU configurations, see the
www.dell.com/poweredgemanuals.
12
Power supply unit (PSU
3)
For more information on the PSU configurations, see the
www.dell.com/poweredgemanuals.
13
OCP NIC port (optional) N/A This port supports OCP 3.0. The NIC ports are integrated on the
OCP card which is connected to the system board.
14 Power supply unit (PSU
2)
For more information on the PSU configurations, see the
www.dell.com/poweredgemanuals.
15
NIC port (1,2) The NIC ports are embedded on the LOM card that is connected to
the system board.
16 Power supply unit (PSU 1) For more information on the PSU configurations, see the
www.dell.com/poweredgemanuals.
For more information on the ports and connectors, see the www.dell.com/poweredgemanuals.
PowerEdge XE8545 system overview
7
To Next Page
Loading...
