Installing Enclosure Components 33
Figure 3-5. Removing and Installing an EMM
Installing an EMM
1
Carefully insert the EMM into the empty module slot.
2
Push the module to the back of the slot until it is firmly seated in the backplane connector (see
Figure 3-5).
3
Push the release lever in (toward the
enclosure
) until the module is retracted into the slot and secure.
4
If necessary, update the firmware for your EMM(s). See the Dell Support website at
support.dell.com
for the latest information on firmware updates.
NOTE: If you have two EMMs installed, both must be running the same firmware level. For information on
updating firmware, see "Downloading Firmware."
For information on EMM connections and cabling, see “Operating Your Storage Enclosure.”
1 release tab 2 release lever
2
1
To Next Page
Loading...
