Dell PowerVault MD3620i - Changing the Virtual Disk Modification Priority

116 Configuration: Disk Groups and Virtual Disks
5 In Advanced virtual disk parameters , you can select:
•
Use recommended settings .
•
Customize settings .
6 If you select Use recommended settings in Advanced virtual disk
parameters
, click Finish . Otherwise, click Next .
7 In the Customize Advanced Virtual Disk Parameters window, select the
appropriate Virtual Disk I/O characteristics type. You can select:
•
File system (typical)
• Database
• Multimedia
• Custom
NOTE: If you select Custom, you must select an appropriate segment size.
8 Select the appropriate Preferred RAID controller module ownership .
9 Click Finish .
The virtual disks are created.
Changing the Virtual Disk Modification Priority
You can specify the modification priority setting for a single virtual disk or
multiple virtual disks on a storage array.
Guidelines to change the modification priority of a virtual disk:
• If more than one virtual disk is selected, the modification priority defaults
to the lowest priority. The current priority is shown only if a single virtual
disk is selected.
• Changing the modification priority by using this option modifies the
priority for the selected virtual disks.
To change the virtual disk modification priority:
1
In the AMW, select the Logical tab.
2 Select a virtual disk.
3 In the toolbar, select Virtual Disk  Change  Modification Priority .
The
Change Modification Priority window is displayed.
book.book Page 116 Tuesday, September 27, 2011 3:13 PM