74 Configuration: About Your Storage Array
• Select the
Setup
tab, and then click
Set
a Storage Array Password
.
• In the AMW, select the
Logical
tab, right-click and select
Set
Password.
The
Set Password
dialog is displayed.
3
If you are resetting the password, type the
Current password
.
NOTE: If you are setting the password for the first time, leave the Current
password blank.
4
Ty p e t h e
New password
.
5
Re-type the new password in
Confirm new password
.
NOTE: The password in Confirm new password and New password must be
exactly the same.
6
Click
OK
.
NOTE: You are not prompted for a password when you attempt to change the
storage array configuration in the current management session.
Password Guidelines
Follow these guidelines when you create a password:
• Use secure passwords for your storage array. A password must be easy for
you to remember but difficult for others to determine. Consider using
numbers or special characters in the place of letters, such as a 1 in the
place of the letter I, or the at sign (@) in the place of the letter a.
• For increased protection, use a long password with at least 15
alphanumeric characters. The maximum password length is 30 characters.
• Passwords are case sensitive.
NOTE: You can attempt to enter a password up to ten times before the storage
array enters a lockout state. Before you can try to enter a password again, you must
wait 10 minutes for the storage array to reset. To reset the password, press the
password reset switch on your RAID controller module, see Figure 3-1.
book.book Page 74 Tuesday, September 27, 2011 3:13 PM
To Next Page
Loading...
