Configuration: About Your Storage Array 81
• Validating an e-mail address—Type the e-mail address in
Email
address
or select the e-mail address in the
Configured email addresses
area, and click
Test
. A test e-mail is sent to the selected e-mail address.
A dialog with the results of the test and any error is displayed.
8
For the selected e-mail address, in
Information To Send
, select:
•
Event Only
—The e-mail alert contains only the event information.
This alert type is the default.
•
Event + Profile
—The e-mail alert contains the event information and
the storage array profile.
•
Event + Support
—The e-mail alert contains the event information
and a compressed file that contains complete support information for
the storage array that has generated the alert.
9
For the selected e-mail address, in
Frequency
, select:
•
Every event
—Sends an e-mail alert whenever an event occurs. This is
the default option.
•
Every x hours
—Sends an e-mail alert after the specified time interval
if an event has occurred during that time interval. You can select this
option only if you have selected either
Event + Profile
or
Event +
Support
in the
Information To Send
drop down list.
10
Click
OK
.
An alert icon is displayed next to each node in the Tree view where an alert
is set.
To ensure that the e-mail is sent successfully:
• Provide an SMTP mail server name and an e-mail sender address for the e-
mail addresses to work.
• Ensure that the e-mail addresses that you had previously configured are
displayed in the
Configured e-mail addresses
area.
• Use fully qualified e-mail addresses; for example, name@mycompany.com.
• Configure multiple e-mail addresses before you click
OK
.
book.book Page 81 Tuesday, September 27, 2011 3:13 PM
To Next Page
Loading...
