Dell PowerVault TL2000 Software Guide

Page 1
Dell™ Model TL2000/TL4000 1GB
iSCSI to SAS bridge iSCSI initiators
Table of Contents
Install the iSCSI Initiator Software (iSCSI-attached Host Servers Only).......................................3
Installing the iSCSI Initiator on a Windows Host Server............................................................3
Installing the iSCSI Initiator on a Linux Host Server..................................................................3
Installing the iSCSI initiator during RHEL 4 installation .........................................................3
Installing the iSCSI initiator after RHEL 4 installation:...........................................................3
Installing the iSCSI Initiator on a RHEL 5 System.....................................................................4
Installing the iSCSI initiator during RHEL 5 installation: ........................................................4
Installing the iSCSI initiator after RHEL 5 installation:...........................................................4
Installing the iSCSI initiator after RHEL 5 installation via the command line: ........................4
Installing the iSCSI Initiator on a SLES 9 System.....................................................................4
Installing the iSCSI initiator during SLES 9 installation:.........................................................4
Installing the iSCSI initiator after SLES 9 installation:............................................................4
Installing the iSCSI Initiator on a SLES 10 SP1 System ...........................................................5
Install the iSCSI initiator during SLES 10 SP1 installation:....................................................5
Installing the iSCSI initiator after SLES 10 SP1 installation:..................................................5
Perform Target Discovery from the iSCSI Initiator........................................................................5
Using Windows Server 2003 or Windows Server 2008 GUI version.........................................5
Using Windows Server 2008 Core Version...............................................................................6
Using Linux Server....................................................................................................................6
Using RHEL 5 or SLES 10 SP1 ................................................................................................6
Configure CHAP Authentication on the Host Server (optional).....................................................7
Using Windows Server 2003 or Windows Server 2008 GUI version.........................................7
Using Windows Server 2008 Core Version...............................................................................7
Using Linux Server....................................................................................................................8
If you are using RHEL 5 or SLES 10 SP1.................................................................................8
If you are using SLES10 SP1 via the GUI.................................................................................8

Dell PowerVault TL2000 Specifications

General

Number of Drives	1 or 2
Number of Slots	24
Type	Tape Library
Drive Types	LTO-4, LTO-5, LTO-6
Interface	SAS, Fibre Channel
Dimensions	8.68 in (22.05 cm) x 19.0 in (48.26 cm) x 30.0 in (76.2 cm)
Tape Drive Compatibility	LTO-4, LTO-5, LTO-6
Power Supply	Redundant power supplies optional
Operating Temperature	50°F to 95°F (10°C to 35°C)
Non-operating Temperature	-40°F to 140°F (-40°C to 60°C)