4. Remove the base cover.
5. Remove the battery.
About this task
The following images indicate the location of the system fan and provide a visual representation of the removal procedure.
Steps
CAUTION:
Do not damage the thermal fan sponge during any replacement procedures. Damaging the sponge
reduces the effectiveness of the heat dispersion.
1. Disconnect the system-fan cable from the system board.
2. Remove the two screws (M2x3) that secure the system fan to the palm-rest assembly.
3. Lift the system fan, along with its cable, off the palm-rest assembly.
Installing the system fan
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the system fan and provide a visual representation of the installation procedure.
Removing and installing components
45
To Next Page
Loading...
