Steps
1. Align and place the smart card reader on the palm-rest assembly.
2. Replace the two screws (M2x3) that secure the smart card reader to the palm-rest assembly.
3. Connect the smart card reader cable to the connector on the USH board.
Next steps
1. Install the assembly inner frame.
2. Install the battery.
3. Install the WWAN card.
4. Install the WLAN card.
5. Install the base cover.
6. Install the microSD card.
7. Install the SIM card.
8. Follow the procedure in After working inside your computer.
60
Removing and installing components
To Next Page
Loading...
