Installing the Coin-Cell Battery
Steps
1. Replace the coin-cell battery in its slot in the computer.
2. Connect the coin-cell battery cable to the system board.
3. Turn the system board over.
4. Install the:
a. System Board
b. Memory
c. Heatsink assembly
d. Fans
e. Hard drive
f. WLAN card
g. Battery
h. Base cover
5. Follow the procedures in After Working Inside Your Computer.
Power button
Removing power button
Steps
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the:
a. base cover
b. battery
c. System board
3. Perform the following steps to remove the power button:
NOTE:
There are two power button options:
ā Power button function with light indicator.
ā Power button with fingerprint reader function without light indicator. (optional)
a. Remove the M1.6x3 (2) screws that secure the power button module to the system board [1].
b. Lift the power button away from the system chassis [2].
Disassembly and reassembly
37
To Next Page
Loading...
