7. Follow the procedures in After Working Inside Your Computer.
Display Assembly
Removing the Display Assembly
Steps
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the:
a. base cover
b. battery
3. Perform the following steps:
a. Release the Mylar tape that secures the display cable to the system board [1].
b. Lift the latch and disconnect the display cable from the connector on the system board [2].
c. Release the Mylar tape that secures the display cable to the system board [3].
d. Remove the M2x4 (2) screws and lift the metal bracket that holds the left video-card fan to the system board [4].
e. Un-route the display cable from the restraints clips [5]
f. Disconnect the display cable from the system board [6].
4. To remove the display assembly:
a. Place the computer at the edge of a flat surface and remove the M2.5x5 (6) screws securing the display assembly to the
system chassis [1].
b. Lift the display assembly away from the system chassis [2].
40
Disassembly and reassembly
To Next Page
Loading...
