Installing the memory module
Prerequisites
About this task
The following image indicates the location of the memory modules and provides a visual representation of the installation
procedure.
Steps
1. Lift the Mylar that covers the memory-module slot.
2. Align the notch on the memory module with the tab on the memory-module slot.
3. Slide the memory module firmly at an angle, into the memory-module slot.
4. Press the memory module down until it clicks into place.
NOTE: If you do not hear the click, remove the memory module and reinstall it.
NOTE: Repeat step 1 to step 4 to remove any other memory modules installed in your computer.
Next steps
1. Install the base cover.
20
Removing and installing components
To Next Page
Loading...
