Steps
1. Align the notch on the solid-state drive with the tab on the SSD1 slot.
2. Slide the solid-state drive into the SSD1 slot.
3. Using the alignment post, place the solid-state drive thermal bracket over the solid-state drive.
4. Align the screw hole on the solid-state drive thermal bracket with the screw hole on the system board.
5. Replace the screw (M2x4) that secures the solid-state drive thermal bracket and the solid-state drive to the system board.
Next steps
1. Install the base cover.
2. Install the battery
3. Follow the procedure in After working inside your computer.
Solid-state drive in SSD2 slot
Removing the M.2 2230 solid-state drive from the SSD2 slot
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the battery.
About this task
NOTE: This procedure applies only to computers shipped with an M.2 2230 solid-state drive installed in the SSD2 slot.
NOTE: Depending on the configuration ordered, your computer may support an M.2 2230 solid-state drive or an M.2 2280
solid-state drive in SSD2 slot.
The following image indicates the location of the M.2 2230 solid-state drive that is installed in the SSD2 slot and provides a
visual representation of the removal procedure.
24
Removing and installing components
To Next Page
Loading...
