Installing the internal chassis speaker
1 Press and hold the tabs on either side of the intrusion speaker, and slide the speaker module into the slot to secure it to the system.
2 Connect the internal chassis speaker cable to the connector on the system chassis.
3 Install the:
a 5.25 inch ODD bracket
b front bezel
c side cover
4 Follow the procedure in After working inside your computer
Air shroud
Removing the air shroud
1 Follow the procedure in Before working inside your computer.
2 Remove the side cover
3 To remove the air shroud:
a Press in the securing tabs by holding the air shroud from both the ends, and then lift the air shroud from the system.
Removing and installing components
35
To Next Page
Loading...
