Figure 1. Remove the SSD frame from SSD slot 4
2. Remove the WLAN bracket away from the computer.
3. Disconnect the two WLAN antennas and speaker cable from their connectors on the system board.
4. Unroute the WLAN antennas and speaker cable from the routing guide on the inner frame.
5. Remove the four (M2x6) and the nine (M2x2) screws that secure the inner frame to the computer chassis.
6. Remove the inner frame from the computer.
Installing the inner frame
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the inner frame and provides a visual representation of the installation procedure.
Removing and installing components
57
To Next Page
