6. Install the:
a. Riser 2 module
b. System cover
vFlash card – optional
Removing vFlash card
Prerequisites
1. If applicable, remove the full height PCIe card in expansion card riser 2.
Steps
1. Locate the vFlash connector on the system board. To locate vFlash connector, see System board jumpers and connectors
section.
2. Remove the vFlash card from its slot [1].
3. Holding the pull tab, lift the vFlash expansion card out of the system [2].
Disassembly and reassembly
63
To Next Page
Loading...
