Installing the heat sink assembly
1. Place the heat sink assembly on the processor.
2. Tighten the captive screws in diagonal order to secure the heat sink assembly to the computer.
3. Connect the heat sink cable to the system board.
4. Install the cover.
5. Follow the procedure in After Working Inside Your Computer.
Removing the processor
1. Follow the procedure in Before Working Inside Your Computer.
2. Remove the:
a. cover
b. front bezel
c. hard drive
d. heat sink
3. To remove the processor:
a. Release the socket lever by pushing the lever down and out from under the tab on the processor
shield [1].
b. Lift the lever upward and lift the processor shield [2].
c. Lift the processor out of the socket [3].
20
To Next Page
Loading...
