Installing the Memory
1. Insert the memory module into the memory socket.
2. Press down on the memory module until the securing clips secure the memory in place.
NOTE: Tilting of DIMM during insertion can cause damage to the DIMM.
3. Install:
a. memory shroud
b. optical drive
c. computer cover
4. Follow the procedures in After Working Inside Your Computer.
Removing the Coin-Cell Battery
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove:
a. computer cover
b. PCIe cards (slot 2 – optional)
3. Press the release latch away from the battery to allow the battery to pop-up from the socket. Lift the
coin-cell battery out of the computer.
Installing the Coin-Cell Battery
1. Place the coin-cell battery into the slot on the system board.
2. Press the coin-cell battery downward until the release latch springs back into place and secures it.
3. Install:
a. PCIe cards(slot 2 – optional)
b. computer cover
4. Follow the procedures in After Working Inside Your Computer.
Removing the Heatsink Assembly
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove:
a. computer cover
b. optical drive (required only for the removal of heatsink assembly for CPU1)
3. Perform the following steps:
25
To Next Page
Loading...
