Setting up the monitor | 23
Setting up the monitor
Connecting the stand
NOTE: The stand riser and stand base are detached when the monitor is
shipped from the factory.
NOTE: The following instructions are applicable only for the stand that
was shipped with your monitor. If you are connecting a stand that you
purchased from any other source, follow the set up instructions that were
included with the stand.
CAUTION: Place monitor of a flat, clean, and soft surface to avoid
scratching the display panel.
To attach the monitor stand:
1. Align the tabs on the stand base with the slots on the stand riser.
2. Insert the stand riser on the stand base firmly.
3. Open the screw handle at the bottom of the stand base, and rotate it clockwise
to tighten the screw firmly. Then close the screw handle.
To Next Page
Loading...
