1. Removing the flange ear castings.
2. Attaching the rail flanges to the posts.
Installing the System
You can mount the system in the 1U front-rack or 1U two-post (flush and
center) configurations. For the 1U two-post (flush and center) configurations,
slide the system into the rails in the same manner as the four-post
configurations.
The following is an example of a 1U front-rack configuration.
Installing a 1U Front-Rack
Configure the rails that are attached to the system.
1. Attach the switch rails (inner chassis members) to the system ( items 1
and 2 in the following figure). Item 3 shows the detail for the front
standoff with the locking tab.
Figure 5. Attaching the Switch Rails
1. Locking feature. 2. Chassis.
Installation
11
To Next Page
Loading...
